Configurations And Remote Control; Cardioid And Endfire Configurations; Technical Specifications - dB Technologies VIOS118 Caractéristiques Techniques

4. CONFIGURATIONS AND REMOTE CONTROL

CARDIOID AND ENDFIRE CONFIGURATIONS

• For vertical cardioid configuration, the assembly limit is 3 overlapping
subwoofers.
• Use DBTECHNOLOGIES COMPOSER to set project parameters.
• Make sure that the local parameters are correctly set on the single
amplifier panels. Make the audio daisy-chain, RDNet and power
connections (for further details, see the previous CONNECTIONS
chapter). In turn-on phase, pay attention to inrush current, written in

TECHNICAL SPECIFICATIONS

evaluating a delayed turn-on of each subwoofer).
• In case of remote control with RDNet and DBTECHNOLOGIES
NETWORK, local settings are by-passed and control is shifted to
software.
• All these parameters can be adjusted with the remote control, once
the RDNet connections have been properly made, using the free
DBTECHNOLOGIES NETWORK software from version 3.3 onwards
(free to download from
section). When using the remote control, the local controls on the
panels of the VIO-S118 modules are by-passed. Using this software,
you can control a larger number of parameters (for more information,
please refer to the full DBTECHNOLOGIES NETWORK manual).
Last settings stored on VIOS118 subwoofers (using DBTECHNOLOGIES NETWORK software),
can be recalled later on the speaker, without RDNet remote control. To do this, turn the
rotary XOVER [Hz] on Service/User position.
VIO-S118
52
chapter (e.g. sizing electrical installation,
www.dBTechnologies.com in the Downloads
English
Cod. 420120259 REV. 1.0