Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
E
F
G
Pre-set weekly temperature programming (automatic mode)
To allow immediate use of the device a standard set-up has been provided for it to operate in heating mode
and another for cooling mode, where the fixed temperature levels are:
Heating
Anti-frost (default 3 °C)
T1
16 °C
T2
18 °C
T3
20 °C
If the temperature trends programmed correspond to your requirements, the device is ready to work
correctly straightaway.
Changing the system's operating mode
Touch the area shown in figure E and continue touching
until a beep indicates the mode is changed between:
System in Heating mode
System in Cooling mode
System off
System in Frost-protection mode
When the system is off ( ), the image in figure F is
displayed on the screen for a few seconds, to indicate
that the programmable thermostat is off; Then the
temperature detected will reappear.
When the system is put into frost-protection mode
G ( ) the arrows let you set the minimum ambient
temperature tolerated; Then the temperature detected
will reappear.
Note.
Programmable frost-protection temperature:
Minimum 3.0°C – Maximum 16.0°C.
Cooling
Off
24 °C
26 °C
28 °C
Publicité
Table des Matières
