Technical Data; Declaration Of Conformity (Doc); Battery Replacement; Maintenance And Cleaning - Conrad Electronic 75 13 51 Mode D'emploi

6.1 Cancelling a radio remote operation
To cancel a radio remote operation from the alarm system memory, do the following:
Step Action Function
1 Press the key
„PROG" on your
alarm system
2 Enter the You arrive in the
four-digits programming mode.
mastercode.
3 Press the You arrive in the
key 0 programming mode for
cancelling of trained
radio remote operations
from the memory of the
alarm system
4 Press the key
6, 7, 8, 9 or 0 (
depending on which
memory space that
has a cancelling radio-
remote control).
** Meaning of the „Zones Status-LEDs" from step 3 of the table above:
„Zones Status-LED". Explanation:
Does not light up At this zone no radio remote operation was trained yet.
Double flashing At this zone a radio remote operation was trained. You
might select this zone, to cancel the radio remote
operation from the memory.
Single flashing At this zone a radio switch module (optionally obtainable)
was trained already. Therefore you should not cancel this
memory space.
Single and subsequently At this zone a radio switch module and a
double flashing Radio remote operation was trained. A radio remote
operation was trained at this zone. You might select this
zone, to cancel the radio remote operation from the
memory.
6.2 Training of radio remote operation on further
radio components of the radio systems
The radio remote operation can be trained on further radio components (e.g. on the optionally
obtainable radio switch module, order no. 751351).
How the training and operation takes place you can read in the manual of the relevant radio
components.

7. Battery replacement

• Remove both screws at the back of the housing.
• Remove the enclosed battery.
• Place new batteries, type „23AE 12V", in the right polarity.
• Recompose the housing and fasten both screws on the backside of the housing.

8. Maintenance and Cleaning

The product requires no servicing except for battery replacement.
Allow any repair to be carried out by a specialist or specialist workshop.
Clean the product with a soft, clean, dry and lint-free cloth. If you wish to remove heavier dirt,
use a cloth, slightly moistened with lukewarm water.
Never use solvent-based cleansing agents, since this might damage the surface of the plastic
housing.
9. Disposal
a) General
Note Please dispose of the device when it is no longer of use, according to the current statutory
requirements.
b) Batteries and rechargeable batteries
3 x short bleep tone confirms You, as the end customer, are legally obliged (Battery Ordinance) to return all used batteries
you the correct code-input. and accumulators. Disposal in the household waste is prohibited!
1 x long bleep tone indicates
a wrong code-input.
As soon as you reach the
programming mode
the „Zones Status-LEDs"
are shining or flashing
on your alarm system.
** Look for the explanation in
the next table
A spoken message
You thus fulfil the legal requirements and make your contribution to protecting the environment!
confirms to you the
succesful cancelling.
10. Notes on the Range
Ranges and disturbances
• The radio remote controle operates in a 433MHz field, which is also used by other radio
• The specified range (of up to 100 m) is the so-called free field range, i.e. the range within visible
• The actual attainable distance between transmitter and receiver in normal operation is heavily

11. Technical Data

Power supply :..............................................1 x battery, type „23AE 12V"
Range:..........................................................up to 100m (free field)
Frequency: ..................................................433 MHz
Dimensions (WxHxD): ..................................35 x 15 x 70 mm
Operating temperature range: ......................-20° to 50°C

12. Declaration of conformity (DOC)

We, Conrad Electronic, Klaus-Conrad-Straße 1, 92240 Hirschau, hereby declare that this pro-
duct adheres to the fundamental requirements and other relevant regulations of Directive
1999/5/EG.
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment
reserved.
© Copyright 2009 by Conrad Electronic SE.
Batteries/rechargeable batteries containing harmful substances are marked with
the following symbols, they point out that they are not allowed to be disposed of in
the domestic refuse. The designations for the decisive heavy metals are: Cd =
cadmium, Hg = mercury, Pb = lead.
You can return used batteries/rechargeable batteries and button cells free of
charge to any authorised disposal station in your area, in our stores or in any other
store where batteries/rechargeable batteries/button cells are sold.
services. This is why there may be a restrictive operation and range due to devices that work
on the same or a neighbouring frequency.
contact between the transmitter and receiver. However in real-life operation, there are ceilings,
walls, garages or adjoining buildings between the transmitter and receiver, which affects and
reduces the range accordingly.
dependent on the installation site and environment. Normally, correct operation without pro-
blems with radio reception should be possible in e.g. a detached house.
You can find the declaration of conformity for this product at www.conrad.com.
These operating instructions are a publication by Conrad Electronic SE, Klaus-
Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).