Before Commissioning - PAIDI E-LION 1 150 147 7151 Mode D'emploi

Danger:
Risk of crushing and shearing!
To avoid the risk of crushing and shearing, the desk with its moving parts must have a minimum distance of 25mm to neighbouring objects, such
as furniture, building parts, etc. When adjusting the desk height, the user must ensure that no one is injured and no objects are damaged. The
desktop must not come into contact with firmly fixed objects, otherwise the desk may tip over.
Before adjusting the desk, move the office chairs, containers, etc. out of reach. Due to the built-in collision protection, fixed objects are usually
detected, but there is still a risk of crushing people! The collision protection is a system protection and NOT a form of personal protection!
Danger:
Use is only permitted in dry indoor areas. Protect the desk frame and especially all electrical components on the desk from moisture, dripping
and splashing water!
Danger:
Children must not play with the product! Cleaning and user maintenance must not be carried out by children without supervision.
Danger:
Be sure to use the supplied power supply cable! Make sure that the power supply cable is not damaged.
Operating the table with a damaged power supply cable is prohibited! It must be replaced to prevent hazards from electric shocks.
Danger:
If the sit-stand desk is visibly damaged or makes unusual noises, it must not be further assembled or used!
Danger:
This product is not intended for use by young children or debilitated persons without supervision.
The desk may be used by children of 8 years of age and older and physically or mentally disabled persons, provided they are supervised or
have received thorough instruction in the use of the equipment and understand its safe use and potential hazards.
Danger:
Never open the motor control unit or other electrical components! There is a risk of electric shock.
All warranty claims are void if the product is opened by unauthorized persons.
Maintenance:
Periodically remove dust and dirt from the outside of the system and make sure there is no damage.
Ensure there is enough cable length so that it is sufficient for raising the desk.
Lay the cable so that it does not create a tripping hazard, even when the desk is raised.
Check the connections, cables and plugs for correct operation as well as the attachment points.
If any components are damaged, the desk must no longer be used and the damaged component must be replaced!
Before installation, disassembly or troubleshooting:
• Turn off the power and unplug the power cord.
• Relieve the desk of any weight.

Before commissioning:

• Ensure that the system has been installed according to the instructions in this installation manual.
• Make sure that the voltage at the control unit is correct before connecting the system to the mains.
Troubleshooting
The most common error codes (EXX) and their cause:
E53-E64 COLLISION
• The desk has collided with an obstacle and the collision protection has been triggered.
→Eliminate the cause of the collision!
E41-E52 OVERLOAD
• Maximum lifting capacity has been exceeded. →Reduce the weight.
E01 INITIALIZATION
• To initialize the desk, move it down completely. To do this, press the "Display Desk Panel"
down and hold it down until the movement is completed.
These assembly instructions were written on the basis of our current technical knowledge. We are constantly working on updating the informati-
on and therefore reserve the right to make technical changes.
Seite 7 von 40
PK-Nr. 3220 Stand 04/2022