!
Warning! / Avertissement! / Waarschuwing! /
GB
Be sure to read and observe these operating instructions before assembling and commissioning the desk!
Non-compliance with the above instructions can lead to accidents with serious personal injury or damage to the product.
Please keep these operating instructions in a safe place! Everyone who connects, installs and uses the system must have access to these
installation instructions.
Please note:
The sit-stand desk may only be used for its intended use, as a writing and working table for the living area.
Do not use the drive system to lift people. Do not sit or stand on the system during operation (risk of injury).
Please note:
The motor control unit may only be operated with the nominal voltage 230-240 V / 50-60 Hz.
Please note:
The sit-stand desk is not designed for continuous operation. The desk height must not be adjusted without interruption for longer than the duty
cycle specified in the instructions (1 min on / 19 min off). The maximum total load of the desk is 80 kg on each column.
Important:
The E-Lion has an important function that prevents the system from overheating. The temperature of the motor and electronics is calculated by
the software during operation and depends on the load, run time, etc. The duty cycle of the E-Lion is 5% ≈ 1 minute of continuous operation at
full load, followed by 19 minutes of pause.
If the E-Lion is used beyond the duty cycle, the system will become hot and stop, and the „Display Desk Panel" will display error code E90.
After a few minutes of pause, the E-Lion can make another run. However, to cool the system down to the default values, the E-Lion needs to
cool down for at least 2 hours with the power supply plugged in.
Please note:
If you interrupt the mains voltage, the software cannot work properly and cannot therefore calculate the temperature correctly. When the system
is switched on again, the software will continue to calculate using the data from the time when the system was disconnected from the mains.
Seite 6 von 40
PK-Nr. 3220 Stand 04/2022
Warnhinweis!
Предупреждение! / 警示!
>25mm
PAIDI Möbel GmbH
!
Hauptstraße 87
D-97840 Hafenlohr
max.
80 Kg
>25mm