Technical Service - Campbell Hausfeld CL155500 Instructions D'utilisation

Grease Port
Grinding Shaft
Grinding
Wheel
Safety Shield
Figure 3
chanGInG GRIndInG wheel
1. Fit enclosed standard wrench on
grinder shaft. Hold shaft securely.
2. Use the spanner wrench to remove
flange nut. Insert spanner wrench
studs into circular openings of flange
nut and turn counter-clockwise to
loosen.
Figure 4
3. Remove grinding wheel from shaft
and replace.
4. Be sure to use proper sized flange set
for grinding wheel. Flanges match 4
inch, 4.5 inch, and 5 inch wheels.
5. Reassemble grinder. Tighten all
fittings.
Throttle Lever
with Safety Latch
www.campbellhausfeld.com
Maintenance
Release all pressure before
attempting to install, service,
relocate or perform any maintenance on
the air system. personal injury and/or
property damage could occur.
stoRaGe
The tool must be lubricated before
storing. Follow the lubrication
instructions with an exception to step
4. Run the tool for only 2 to 3 seconds
so more oil will remain in the tool when
storing.

technIcal seRvIce

For information regarding the operation
or repair of this product, please call
1-855-504-5678.
Cl155500
Air Inlet
(Oil Here)
5