Speed Adjustment - Campbell Hausfeld CL155500 Instructions D'utilisation

Operating Instructions
Pre-Operation
(Continued)
BEFORE the initial use and BEFORE and
AFTER each additional use.
AutomAtic lubricAtion
The recommended method for
lubrication is with an air line lubricator
installed as part of the air piping system.
See Figure 1. Use Campbell Hausfeld air
tool oil ST127000AV or equivalent ISO
grade 32 oil.
mAnuAl lubricAtion
If an air line lubricator is not used, the
tool must be lubricated daily.
supply before lubricating.
1. Disconnect the air tool from the air
supply.
2. Turn the air tool upside down.
3. while pulling the trigger, squeeze
approximately a 1/4 oz. of Campbell
Hausfeld airtool oil in the air inlet. If
applicable, switch the forward and
reverse valve in both directions.
lubricated, oil will discharge through
the exhaust port during the first few
seconds of operation. The exhaust port
must be directed away from your body
before applying air pressure.
4. Connect the air tool to the air supply
and cover the exhaust port with a
towel (refer to replacement parts
manual for tool features). Run the
tool in both the forward and reverse
directions, if applicable, for 20 to 30
seconds. Oil will discharge from the
4
This air tool
requires lubrication
Disconnect the
air tool from the air
After an air tool
has been
www.campbellhausfeld.com
exhaust port when air pressure is
applied.

speed adJustMent

Some tools are equipped with a speed
regulator. Turn the adjustment screw
in the regulator body until the desired
speed is attained.
Fully
Closed
Position
Fully
Open
Position
Figure 2
Operation
air supply before attaching or changing
grinding wheels. Do not operate the
tool if wheel is not securely tightened.
Always replace a worn or damaged
wheel, otherwise serious injury could
occur.
1. Center a grinding wheel on the
shaft, and make sure the collet nut
is tightened securely. Be sure the
grinding wheel is rated for the RPM of
the tool.
2. Connect the grinder to the air supply.
3. Use bottom outer surface of grinding
wheel as cutting surface. Do not use
excessive force.
Regulator Body
Adjustment Screw
Regulator Body
Adjustment Screw
Disconnect the
grinder from the