Technical Service; Safety Instructions - Campbell Hausfeld XT251000 Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

AIR-FLOW/SPEED ADJUSTMENT
The air-flow regulator controls how much air
enters the motor which defines the motor speed/
power. To adjust the amount of air flowing to the
motor, turn the air regulator adjustment screw in
either direction (turns 360 degrees) until desired
flow/motor speed is achieved. To prevent injury,
do not adjust power settings while the tool is
running.
STORAGE
Lubricate your angled die grinder before storing. Follow the air motor
lubrication instructions with an exception to step #5. Only run the die grinder
for 2-3 seconds (instead of 10 seconds) because more oil needs to remain in
the tool when storing. Store your tool in a cool dry place.

TECHNICAL SERVICE

For information regarding the operation or repair of this product, please visit
www.campbellhausfeld.com.

SAFETY INSTRUCTIONS

This manual contains information that is very important to know and
understand. This information is provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help recognize this information, observe the
symbols found on page 8. The Safety Symbols throughout this manual are to
alert you to important safety hazards and precautions.
With any piece of equipment, new or used, the most important part of its
operation is SAFETY!
Campbell Hausfeld encourages you to familiarize yourself with your new
equipment and stresses safe operation.
The next few pages of this manual are a summary of the main safety aspects
associated with this unit. Be sure to read and understand completely before
operating the machine.
The symbols used throughout the operation and maintenance sections of
this manual call attention to safety procedures.
The DANGER, WARNING, CAUTION, and NOTICE notifications
and instructions in this manual cannot cover all possible condi-
tions and situations that may occur. It must be understood by
the operator that caution is a factor which cannot be built into
this product, but must be supplied by the operator.
5

Publicité

Table des Matières
loading

Table des Matières