Geemarc CLEARSOUND AMPLICALL 16 Mode D'emploi page 6

INSTALLATION
Note: Do not use a rechargeable battery. Do not put the
used battery into the household rubbish, pay attention to
battery regulations regarding battery disposal.
Volume Control Slide Switch
Set the volume of the alarm sound or power on/off.
The Pairing Procedure:
The supplied door bell have been paired with the base, it
is no need to pair. If the door bell is not linked to the base
or you want to pair with other door bell, please follow
below procedure to pair.
Press and hold the Pairing/Test button of the unit and the
Door bell button until the strobe flasher LED flashes, the
unit makes a beep sound to confirm pairing successfully.
To check whether the device is working properly and has
been paired correctly, press the pairing/testing button
once. The device should sound the alarm and flash.
Operation
Once the Amplicall 16 and the Door bell have been
placed in the required locations and all required batteries
have been inserted, you are ready to use the device.
To use the device, the person who needs assistance
must press the door bell button of the door bell.
5