Geemarc CLEARSOUND AMPLICALL 16 Mode D'emploi page 5

INSTALLATION
Table Mounting
If you want to mount the unit on the table, only put it into
the base cradle, and then place the base cradle on the
table.
Change the Battery of the indoor unit
(option)
The unit requires 4×AA batteries
1. Open the battery door.
2. Insert four AA batteries into the compartment.
3. Snap the battery compartment door back into place.
Note: when the indicator keep flashes, replace the batteries.
You can add one adaptor in option (contact 01 707- 384438)
Change the Battery of the Door bell
The door bell is supplied with a 23A 12V battery. The
Door bell is supplied ready to use, it is not necessary to
open the bell push when you first install the Amplicall 16.
To replace the battery, unscrew the door bell from the
wall, unscrew the five screws located on the base and
open the box to get access to the battery compartment.
Replace the battery, replace back and remount.
4