Check Pump Oil; Add Fuel - Generac 6565 Manuel De L'opérateur

CHECK PUMP OIL

1. Place power washer on a flat, level surface.
2. Clean area around oil fill and remove vented cap/dipstick (B)
(Figure 8).
Figure 8 – Check Pump Oil
B
3. Check to confirm oil level is between the "L" and "H" on the
dipstick (Figure 9). If oil is required, see Maintenance section.
DO NOT OVERFILL.
4. See the Maintenance section for additional information on
pump oil maintenance.
5. Install oil dipstick until finger tight.
6. Clean up any spilled oil.
Figure 9 – Pump Oil Dipstick
A
Acceptable Oil
"H"
Level Range
"L"

ADD FUEL

Fuel must meet these requirements:
• Clean, fresh, unleaded gasoline.
• A minimum of 87 octane/87 AKI (91 RON).
• Gasoline with up to 10% ethanol (gasohol) is acceptable.
Avoid power washer damage. Failure to follow Operator's
Manual for fuel recommendations voids warranty.
• DO NOT use unapproved gasoline such as E85.
• DO NOT mix oil in gasoline.
• DO NOT modify engine to run on alternate fuels.
To protect the fuel system from gelling, mix in a fuel stabilizer when
adding fuel. See Storage. All fuel is not the same. If you experience
starting or performance problems after using fuel, switch to a
different fuel provider or change brands.
Explosion and Fire. Fuel and vapors are extremely
ammable and explosive. Add fuel in a well
ventilated area. Keep re and spark away. Failure to
do so will result in death or serious injury.
WHEN ADDING FUEL
• Turn power washer OFF and let it cool at least two (2) minutes
before removing fuel cap. Loosen cap slowly to relieve pressure in
tank.
• Fill fuel tank outdoors.
• DO NOT overfill tank. Allow space for fuel expansion.
• If fuel spills, wait until it evaporates before starting engine.
• Keep fuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
• DO NOT light a cigarette or smoke.
1. Clean area around fuel fill cap, remove cap.
2. Slowly add regular unleaded fuel to fuel tank. Be careful not
to overfill. Fill to bottom of filter screen, this will allow for fuel
expansion (Figure 10).
3. Install fuel cap and let any spilled fuel evaporate before
starting engine.
Figure 10 – Adding Fuel
Set-up
NOTE:
DANGER
(000105)
000117
7