Check Pump Oil; Add Engine Oil - Generac 231461 Manuel

General Information and Setup
Figure 2-3. Insert Nozzles
5. See Figure 2-4. Attach siphon tube.
Figure 2-4. Attach Siphon Tube

Check Pump Oil

1. Place power washer on a flat, level
surface.
2. See Figure 2-5. Clean area around oil fill
and remove vented cap/dipstick (A).
A
Figure 2-5. Check Pump Oil
3. See Figure 2-6. Check to confirm oil level
is between the "L" and "H" on the dipstick
when breather is screwed in. If oil is
required, see
Change Pump
OVERFILL.
4. Install oil dipstick until finger tight.
5. Clean up any spilled oil.
4
009075
A
009076
B
009079
Oil. DO NOT
Figure 2-6. Pump Oil Dipstick

Add Engine Oil

Unit is shipped with no oil in the engine.
Add engine oil before starting. See
Recommendations.
1. Place power washer on a level surface.
2. Verify oil fill area is clean.
3. Remove oil fill cap and wipe dipstick clean.
Figure 2-7. Remove Dipstick
4. Add recommended engine oil.
NOTE: Some units have more than one oil fill
location. It is only necessary to use one oil fill
point.
5. Thread dipstick into oil filler neck. Oil level
is checked with dipstick fully inserted.
6. See 2-8. Remove dipstick and verify
Figure
oil level is within safe operating range.
Figure 2-8. Safe Operating Range
7. Install oil fill cap/dipstick and hand-tighten.
Owner's Manual for Power Washer
H
L
000268
Engine Oil
000115
000116