Rothenberger Industrial 1500000041 Mode D'emploi page 12

- If the soldering iron is used for longer periods we recommend that you clean the tip
occasionally with the cleaning sponge (5) and re-tin the tip if necessary.
Use a de-soldering braid (not supplied) to clean the joint, to de-solder and to remove excess
solder from the joint. Place the de-soldering braid over the excess solder and heat it with
the soldering tip (6). The molten solder flows on to the de-soldering braid.
- The soldering iron must be stored in the soldering iron holder (3) on the soldering stand (2)
during breaks in your work.
- After you finish soldering disconnect the soldering iron from the mains and allow it to cool
down in the soldering iron stand (3).
Caution:
The soldering iron, the soldering tip and the soldering iron holder remain
hot for some time after disconnection from the mains!
RECYCLING
This symbol indicates that this product may not be disposed of together with domestic
waste in compliance with the (2002/96/EC) Regulation pertaining to waste electrical and
electronic devices (WEEE). This product must be handed in at an designated collection
point. This can occur, for example, by returning it when a similar product is purchased
or by handing it in at an authorised collecting point for the recycling of waste electrical
and electronic equipment. Owing to potentially hazardous substances that are frequently
contained in waste electronic equipment, incorrect handling of waste equipment may
have a negative impact on the environment and on the health of human beings. By
disposing of this product correctly, you are also contributing towards an efficient use
of natural resources. Information on collecting points for waste equipment can be
obtained from your local authority, the public waste disposal authority, an authorised
institution for the disposal of waste electrical and electronic equipment or the waste
collection services.
12