Print Out Configuration Values; Interface Parameters; Configuration Default - Ecolab LMIT 08 Notice Technique

8.4.4

Print out configuration values

Fig. 8.29
In the event of a fault, check printer connection and printer status (online).

Interface parameters:

Example for a configuration print:
8.4.5

Configuration default

NOTE
This function is only offerd, if code number protection is not activated.
Fig. 8.30
With the choice of the function "configuration default" all adjustments, which were made under
chapter 8.4.3.2
(chapter 8.6.2) are deleted and replaced by default values.
417101109_LMIT08.doc
The RS232 printer interface is only suitable for printing out
parameterization data but not for on-line listing of conductivity
and temperature values!
Baud rate
Parity
Data bits
Stop bits
Protokol
If you choose the function "configuration default this menu
appears:
up to chapter 8.4.3.7 as well as the adjustment in the CIP ranges 1 – 4
9600
none
8
1
XON/XOFF
L M I T 0 8 version 1.8
configuration
Mode: CIP
- Language select : ENGLISH
- ref. temperature : 20°C
- curr. outp. cond.conc
- curr. outp. tmp : 4mA...20mA
- zero point tmp : 4mA =
- SPAN Tmp : 20mA = 100°C
- armaturefactor : 1.020
CIP range 1
- type of meas. : cond.-measure
- Tkα adjustment : 2.30 %/K
- meas. range : 0.. 2 mS/cm
- zero point cond. : 4mA = 0.00mS/cm
- SPAN cond : 20mA = 2.00mS/cm
CIP range 2
- type of meas. : conz.-measure
- product : mip FL
- range : 0... 5 %
- zero point conc : 4mA = 0.00 %
- SPAN conc : 20mA = 2.00 %
CIP range 3
- type of meas. : conz.-measure
- product : horo. flüs.
- range : 0... 5 %
- zero point conz : 4mA = 0.00 %
- SPAN conz : 20mA = 1.00 %
CIP range 4
- type of meas. : cond.-measure
- Tkα-adjustment : 2.10 %/K
- meas. range : 0.. 2 mS/cm
- zero point cond : 4mA = 0.00mS/cm
- SPAN cond : 20mA = 2.00mS/cm
- 71 -
device number: ---
: 4mA...20mA
0°C
Rev. 3-01.10