Jbnum-Cps3 Installation - Cristec Battery Monitor JBNUM-CPS3 Manuel D'utilisation

Battery Monitor JBNUM-CPS3
Battery Monitor JBNUM-CPS3 Installation
- Proceed a cutting-off in the on-board panel where the unit will be installed
according to the here-after drawing. (Panel cutting in page 41)
100 110
Ø 4
100
110
- Install the LCD PCB inside the on-board panel cutting-off.
- Fix the on-board panel cutting-off through 4 off M3 screws cylindrical slit top + 4
off M3 nuts + 4 off M3 plain washers. The screw's length should be chosen
depending on the thickness of the main on-board panel where the monitoring system
will be fitted in.
29
www.busse-yachtshop.de | info@busse-yachtshop.de