Touch Control Safety Functions - Burg BCA60-TR Instructions D'utilisation Et D'installation

6
The following safety functions are available to avoid unintended operations
of the hob control.
Sensor Safety Cut Off
To prevent the appliance from unwanted, random sensor operation, sensor
monitoring is included.
In case of one or more buttons are pressed longer than 12 sec, the sensor
monitoring routine indicates with a beep, that wrong operation (pot or other
object placed on the button, sensor failure, etc.) and switches off the
appliance.
The safety turn off causes the hob to turn off to standby. An ´F` will flash
in all heater displays once before switching to standby.
If residual heat is present, ´H` will be displayed in the appropriate heater
displays.
Over Temperature Switch Off
Due to the control panel being close to the front two heaters it can get too
hot to touch if the pans have been badly placed so the bottom edge of the
pan is close to but not touching the control buttons.
To prevent the hob control unit from damage, the control monitors the
temperature and switches off, if the control panel exceeds 60ºC. All 4 heater
displays show ´t`, until the hob cools down.

TOUCH CONTROL SAFETY FUNCTIONS