Burg BCA60-TR Instructions D'utilisation Et D'installation page 36

Set Cooking Level With and Without Heat Boost
A l l h e a t e r s a r e e q u i p p e d w i t h h e a t b o o s t f u n c t i o n a l i t y.
If the heat boost is active, then the heater will be operated with maximum
power for the period of the heat boost time, which is dependent on the
selected heat setting. This is indicated by a flashing ´A`, alternating with the
heat setting value (e.g. ´A` and then ´9`) in the heater display. Once the
heat boost time has ended, only the heat setting will be displayed.
If you want to use heat boost level 9 must be selected by pressing
from level 0. After setting the heat to level 9 , ´A`and the heat setting will
be displayed alternately. This means that level 9 and heat boost is active.
Continue to press the
The heat boost can be turned off by pressing
selected.
If the heat boost should be used, it can always be activated by actuating
again if the heat setting is set to level 9. In the heat display ´A/9` flashes.
Turn Off Individual Heaters
A selective heater can be turned off in two ways:
. Simultaneous operation of
· Reduction of the heat setting to ´0` by operating
Simultaneous operation of
The corresponding heater must be chosen with one of the Active/Deactive
Heater Button , the Decimal Point of the selected Heater Display flashes.
To turn off the heater,
signal sounds and ´0` appears in the heat setting display.
If there is a residual heat for this heater remaining, this will be indicated by
a static display ´H` in the heat setting display.
Reduction of the heat setting to ´0` by operating
button to set a lower heat setting.
and buttons
and buttons
and must be pressed at the same time. A beep
starting
until heat setting ´0` is
button
button
.