Mounting The Stove Sensor With Overtemperature Protector; Optional Door Switch - Karibu Modern Finnisch Mode D'emploi

Assembling Instructions for Specialist Staff Only
2 Mounting the stove sensor FI
with overtemperature protector
Figure 2 3
Mount the stove sensor with overtemperature protector
FI in the sauna cabin about 15 cm below the ceiling
and above the heating system, or in accordance with
specifications of the cabin manufacturer.
The stove sensor with overtemperature protector can
only be connected with the attached 150°C temperature-
resistant connecting line.
On the outside of the sauna cabin the temperatur
resistant connecting line can be extended with
customary lines.
CAUTION - Double insulation is required:
Run the stove sensor line separate to other power
cables in the connection range for extra-low volta-
ge of the control.
Protect single insulated lines with a pipe (double
insulation).
1. Run four-pin line 5 to mounting site of stove sen-
sor 4 at the cabin wall and fix in position with
wiring clips.
2. Separate two half shells 1 of the stove sensor
4 and clamp to four terminal connectors of the
temperature-resistant connection line according
to the circuit diagram.
3. Insert round adaptor plate 2 with the connection-
cross-wise in the half shells 1, close half shells
and tighten with the two recessed head screws
3 which are 9 mm in length. Check if the stove
sensor 4 is safely locked.
4. Perform tests according to the chapter on "Tests".
5. Bolt stove sensor 4 to the cabin wall in alignment
with the heater, keep a distance of 15 cm to the cei-
ling, or mount in accordance with specifications of
the cabin manufacturer, using two wood screws 6.
3

Optional door switch

Mount the optional door switch according to the as-
sembling instructions attached to the door switch, or
in accordance with the specifications of the cabin ma-
nufacturer.
• 18 •