VONROC LM504DC Traduction De La Notice Originale page 16

EN
flower bed in the middle of the lawn, cut a row
or two around the circumference of the bed.
• Pay special attention when changing direction.
• Always mow along inclines (not up and down).
You can prevent the lawn mower from slipping
down by holding a position at an angle up-
wards.
• Select the cutting height according to the
length of the grass. Make several passes to
prevent that too much grass is cut at one time.
• Empty the grass box regularly.
Note: The operating time of the rechargeable
batteries and therefore the area in square meters
that can be covered with a single battery charge
is largely dependent on the state of the grass (e.g.
density, moisture, height, cutting height, etc.) and
the mowing speed (walking speed). To adjust the
area coverage to your individual requirements, it is
recommended that you mow the lawn more often,
with a higher cutting height and at an appropriate
speed. Frequently turning the equipment on and
off while mowing will also reduce the amount of
area that you can cover. If the operating time of
the rechargeable batteries (area coverage) is still
unsatisfactory in spite of the above measures, you
can remedy the problem by using rechargeable
batteries with a larger capacity (Ah).
After use
1. After use, switch the product off, disconnect the
safety key (21).
2. Remove the battery packs (23).
3. Check, clean and store the product as descri-
bed in chapter 'maintenance'.
5. MAINTENANCE
Switch off the equipment, wait for the blade
to stop and remove the battery. There is a
risk of injury.
Cleaning
Your mower has been designed to operate over a
long period of time with minimum of maintenance.
Continuous satisfactory operation depends upon
proper mower care and regular cleaning.
• Keep the mower clean and dry.
• Regularly use a blunt scraper to remove grass
and dirt from the mower
• To clean the mower, use only mild soap and a
16
damp cloth. Never let any liquid get inside the
tool and never immerse any part of the tool
into liquid. Do not use any abrasive or solvent -
based cleaner.
Stop the blade(s) if the machine has to be tilted for
transportation when crossing surfaces other than
grass, and when transporting the machine to and
from the area to be used. Do not start the machine
when standing in front of the discharge opening.
Storage
Always allow the machine to cool down before sto-
ring. Replace worn or damaged parts for safety. Use
only genuine replacement parts and accessories.
1. Switch the product off, disconnect the safety key
(21) and remove the battery pack (23) before
storage.
2. Clean the product as described above.
3. Store the product and its accessories in a dark,
dry, frost-free, well-ventilated place. The ideal
storage temperature is between 10 °C and 30 °C.
4. Always store the product in a place that is inac-
cessible to children.
5. We recommend using the original package for
storage or covering the product with a suitable
cloth or enclosure to protect it against dust.
Transportation
1. Switch the product off, disconnect the safety
key (21) and remove the battery pack (23)
before transporting it anywhere.
2. Always transport the product by its transport
handle (7).
3. Protect the product from any heavy impact or
strong vibrations which may occur during trans-
portation in vehicles.
4. Secure the product to prevent it from slipping or
falling over, damage and injury.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
WWW.VONROC.COM