VONROC LM504DC Traduction De La Notice Originale page 14

EN
Assembling the lower handle (Fig. A, B)
1. Insert the lower handle (14) into the intended
hole of the lawn mower body, as shown on figu-
re B. Ensure the hole in the lower handle (14)
aligns with the hole in the lawn mower body.
2. Insert the screw in the hole and tighten by turn-
ing clockwise, as shown on figure B.
3. Repeat these steps for the other lower handle
(14).
Assembling the upper handle (Fig. A, C, D)
1. Attach the upper handle (1) to the lower handle
(14), using the supplied bolts (15B) and handle
knobs (15A) as shown on figure C. Make sure
the safety switch (3) assembly is on the right
side when standing behind the lawn mower.
2. Fixate the cable to the handle by using the
cable holder (6), as shown on figure D.
Note: When handle knobs (15A) are loosened, the
upper handle (1) can be folded down for storing
the lawn mower. Ensure that the power cable is not
caught.
Assembling and mounting the grass box
(Fig. A, E, F, G, H)
The lawn mower shall not be operated
without either the entire grass catcher or
the guard in place.
It is possible to use the lawn mower with or without
grass box. Remember though that when cutting
without the grass box, the grass box lid (11) must
be lowered. Do not operate the mower with outlet
lid lifted.
1. Join the two halves of the grass box basket
(10), as shown on figure E.
2. Mount the grass box cover (12) onto the assem-
bled grass box basket (10), as shown on figure F.
3. Mount the Grass box carrying handle (16) onto
the grass box cover (12), as shown on figure G.
4. Figure H shows a correctly assembled grass box.
5. Lift the grass box lid (11) and attach the assem-
bled grass box onto the lawn mower. Ensure the
indents in the grass box align properly with the
holders of the lawn mower body.
Note: the grass box is fitted with a grass level
indicator (13), which shows the amount of mowed
grass. As long as the grass box is not full, the indi-
14
cator will be opened. When the grass box is full, the
indicator will close. In that case immediately stop
mowing and empty the grass box. This indicator is
only a rough guideline, of which the functionality
depends on the condition inside the grass basket.
Replacing the cutting blade (Fig. A, M)
Before any work on the power tool, remove
the battery.
When replacing the cutting blade, wear
protective gloves. Danger of injury when
touching the cutting blade.
Only use blades that are recommended by
the manufacturer.
1. Remove the grass box.
2. Turn the mower onto its side.
3. Firmly hold cutting blade using protective gloves.
4. Turn the cutting blade fixing screw counter-
clockwise to loosen it, as shown on figure M.
5. Replace or sharpen the cutting blade.
6. Install the cutting blade, use the above pro-
cedure in reversed order (holes in the cutting
blade must be seated on the spindle pins).
7. It is best to entrust sharpening or replacement
of cutting blade to a qualified person. Only
original parts should be used. All defects should
be repaired by service workshop authorized by
the manufacturer.
4. OPERATION
Before using, always visually inspect to see
that the blades, blade bolts and cutter
assembly are not worn or damaged. Please
remove the battery from the tool. Replace
worn or damaged blades and bolts in sets
to preserve balance.
If the machine starts to vibrate abnormally
(check immediately):
- inspect for damage,
- replace or repair any damaged parts,
- check for and tighten any loose parts.
WWW.VONROC.COM