VONROC LM504DC Traduction De La Notice Originale page 15

Immediately switch off the machine in the
following cases:
- whenever you leave the machine,
- before clearing blockages or unclogging
chute,
- before checking, cleaning or working on
the machine,
- after striking a foreign object. Inspect
the machine for damage and make re-
pairs before restarting and operating the
machine;
Be careful during adjustment of the
machine to prevent entrapment of the
fingers between moving blades and fixed
parts of the machine.
Adjusting the cutting height (Fig. A, I)
Switch off the equipment, wait for the blade
to stop and remove the battery. There is a
risk of injury.
Depending on the preferred cutting height, you
can adjust the heigh level in one of five positions.
Adjust the cutting height according to the needs of
your lawn. The cutting height depends on the kind
of lawn and its actual height. When mowing high
grass, start with the maximum cutting height and
make a second cut with a lower cutting height.
A higher cut height should always be selected for
the first cut of the season.
1. Pull the height adjustment lever (17) outwards
(away from the machine housing) as shown on
figure I.
2. Whilst holding the height adjustment lever (17)
in outwards position, push it forward or bac-
kward to the desired cutting height.
3. Release the lever (17) and ensure it engaged in
the slot properly.
NOTE: There are 5 cutting height levels available:
30mm, 40mm, 50mm, 60mm, 70mm.
Switching the machine on/off (Fig. A, N)
Before starting, put the product on a flat
surface free of high grass.
Clean the underside of the deck before
turning on the machine.
WWW.VONROC.COM
Keep your feet well away from the cutting
blade.
Do not tilt the product when starting the
motor.
1. Ensure the safety key (21) is inserted in the
designated spot underneath the battery cover
(19).
2. To start the machine, press and hold the safety
button (3) and press the on/off switch (2).
Whilst holding the on/off switch (2), you can
release pressure on the safety button (3).
3. To stop the machine, release the on/off switch
(2) and wait until cutting blade stops rotating.
Operating the mower (fig. A, O)
Always ensure that a safe distance
(provided by the length of the long handles)
is maintained between the user and the
mower housing.
Be especially careful when mowing and
changing direction on slopes and inclines.
Maintain a solid footing and wear sturdy,
non-slip footwear and long trousers. Always
mow along the incline (not up and down).
For safety reasons, the lawn mower may
not be used to mow inclines whose
gradient exceeds 15 degrees.
Use special caution when backing up and
pulling the lawn mower. Tripping hazard!
Before use
• Make sure that the lawn is clear of stones,
sticks, wire or other objects that could damage
the product or its product.
• Do not cut wet grass because it tends to stick
to the underbody of the product, preventing
the proper discharge of grass clippings, and it
could also cause you to slip and fall.
• Never cut off more than one-third of the total
length of the grass for a healthy lawn. In the
autumn, lawns should only be cut as long as
there is growth.
• Slowly push the product forward, do not force.
• Mow in slight overlapping rows. The most effec-
tive hat all the lawn is cut without missing any
spots, as shown on figure O.
• Circle around flower beds. When reaching a
EN
15