Jam HX-HP101 Manuel D'instructions page 3

SET UP
CHARGING YOUR HEADPHONES
The "Already There" headphones are powered by a
rechargeable battery. The headphones come pre-
charged; however, for optimal play time, be sure to
charge before first use.
A – Unwrap the charging cable and plug the micro
USB end into the charging port on the headphones.
B – Connect the larger USB plug to your computer
or a powered USB AC adapter. An AC adapter is not
included in the box, but you can use the one for
your cell phone or pick one up next time you're at
the store.
C – When the LED flashes red, it indicates that the
battery is low and it's time to plug in and recharge.
Charge for about 2 hours to get up to 24 hours of play
time; while charging, the light will stay solid red.
Once fully charged, the LED will turn off.
USE
A – TURN ON YOUR HEADPHONES
Long press the "play/pause" button for 3 seconds to
turn on your headphones.
B – CONNECTING TO A DEVICE
Once turned on, the headphones will immediately
search for a device to pair to; the LED will blink red and
blue alternately. Enable Bluetooth® on your device.
From the Bluetooth® menu, select "Jam Already
There." Once it's connected, you will hear a tone and
the LED light will flash blue every five seconds.
Once paired, your device and headphones will find
each other every time, as long as your device's
Bluetooth® is on. If you're connecting to a computer,
you may have a few more steps on that end.
You'll have to get that information from the
computer company.
Depending on your device, you may be prompted to
enter a pairing code. If so, use "0000" as the code.
Holding down the "<" and ">" buttons at the same time,
for 3 seconds, will disconnect a paired device.
EN
You may also connect your device to Already There
using an aux cord, which is included.
Jam Already
Already
There
There
2hrs 24hrs
...3s
0000
0000
...0.5s
3