Main Broom Disassembly/Assembly - Nilfisk Alto FLOORTEC 350 Manuel D'utilisation

ENGLISH

MAIN BROOM DISASSEMBLY/ASSEMBLY

CAUTION!
It is advisable to wear protective gloves when
replacing the main broom because there can be
sharp debris between the bristles.
1. Drive the machine on a level ß oor.
2. Turn the main switch (1) to "0".
3. Remove the hopper (9).
4. Loosen the handwheels (A, Fig. 5) completely on the left
side of the machine.
5. Remove the lid (A, Fig. 6) by grasping it on the points (B).
6. Grasp the main broom (A, Fig. 7) on the points (B) and
(C), then disconnect it from the drive hub (D) by pulling it in
the direction shown by the arrow (E); then remove it in the
direction shown by the arrow (F).
7. The new main broom must be installed with the bristles
rows bent as shown in the Þ gure.
8. Install the new broom by performing steps 3 to 6 in the
reverse order.
9. Adjust the height of the new broom according to the
procedure shown in the previous paragraph.
D
14
Bedienungsanleitung auf www.gluesing.net
USER MANUAL
E
FLOORTEC 350
A
C
F
Figure 7
A
Figure 5
B
Figure 6
A
B
146 3083 000(2)2008-11 A
S311354
S311355
S311356