Maintenance; Scheduled Maintenance Table; Battery Charger Cable Check - Nilfisk Alto FLOORTEC 350 Manuel D'utilisation

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by proper and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be deÞ ned by the person in charge of the maintenance.
WARNING!
To perform maintenance procedures, the machine must be off and, if necessary, the batteries must be
disconnected.
Moreover, carefully read the instructions in Safety paragraph.
All scheduled or extraordinary maintenance procedures must be performed by qualiÞ ed personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure

Battery charger cable check

Side and main broom height check and adjustment
Skirt height and operation check
Dust Þ lter cleaning and integrity check
Hopper gasket check
Filter shaker operation check
Driving belt and clutch visual inspection
Driving belt tensioner adjustment
Nut and screw tightening check
Motor carbon brush check or replacement
(*) For the relevant procedure, see the Service Manual.
(1) And after the Þ rst 8 hours.
BATTERY CHARGER CABLE CHECK
Carefully check the battery charger cable (18) and the relevant plug for wear, cuts, cracks or other damages.
If the battery charger cable or the relevant plug is damaged, contact the NilÞ sk Alto Service Center.
146 3083 000(2)2008-11 A
Bedienungsanleitung auf www.gluesing.net
USER MANUAL
Every 10 hours Every 50 hours
FLOORTEC 350
ENGLISH
Every 200 hours Every 400 hours
(*)
(*)
(*)
(*) (1)
(*)
11