Side Broom Height Check And Adjustment; Side Broom Disassembly/Assembly - Nilfisk Alto FLOORTEC 350 Manuel D'utilisation

ENGLISH
SIDE BROOM HEIGHT CHECK AND
ADJUSTMENT
1. Check the side broom distance from the ß oor as shown
below:
• Drive the machine on a level ground and lower the side
broom.
• Keep the machine stationary and turn on the side
broom for a few seconds.
• Turn off the side broom by pressing the switch (1), then
lift it and move the machine.
• Check that the side broom print is as shown in the
Þ gure (A, Fig. 1): the side broom must touch the ground
along a circle arc ranging from "10 o'clock" position to
"3 o'clock" position.
• If the print is not within speciÞ cations, adjust the broom
height as shown in step 2.
2. Turn the knob (13) clockwise and counter-clockwise to
adjust the broom height.
3. Perform step 1 again to check the proper adjustment of the
side broom height.
4. When the broom is too worn to be adjusted, replace it as
shown in the next paragraph.

SIDE BROOM DISASSEMBLY/ASSEMBLY

CAUTION!
It is advisable to wear protective gloves when
replacing the side broom because there can be
sharp debris between the bristles.
1. Drive the machine on a level ß oor.
2. Turn the main switch (1) to "0".
3. Lift the side broom.
4. Loosen the knob (A, Fig. 2) inside the side broom, then
remove the broom (B) by disengaging it from the pins (C).
5. Install the new broom on the machine engaging it on the
pins (C), then tighten the knob (A).
6. Adjust the height of the new broom according to the
procedure shown in the previous paragraph.
12
Bedienungsanleitung auf www.gluesing.net
USER MANUAL
FLOORTEC 350
10
Figure 1
B C
Figure 2
146 3083 000(2)2008-11 A
A
3
S311350
A
S311351