Domo DO9200IB Mode D'emploi page 32

DO9200IB
USE
Before using the ice cube maker for the first time: wait 2 hours after putting the
appliance in place and leave the lid open for at least 2 hours.
It is recommended to use spring water in the appliance.
1. Place the ice cube maker on a flat and stable surface and make sure that the
ventilation openings are not blocked.
2. Open the lid and take out the ice basket so you can pour water into the water tank.
3. Caution: Make sure that the water level is lower than the maximum indication. If
the water tank is filled above the MAX indication, drain the excess water through
the drain hole at the bottom of the ice cube maker.
4. Place the basket back into the appliance and close the transparent lid.
5. Insert the plug into the socket and press the POWER button to switch on the
appliance.
6. Select the desired ice cube size with the SELECT button. S for small, L for large.
The standard setting is L, large.
7. If the room temperature is lower than 15°C, it
is best to select small ice cubes (S). If the room
temperature is higher than 30°C, it is best to select
large ice cubes (L).
8. During the first 3 cycles, the ice cubes may be
smaller and more irregular in size.
9. When the ice basket is full, immediately remove the
ice from the ice basket.
CLEANING AND TIPS
• Switch off the appliance and unplug before cleaning. Also remove all ice cubes.
• Regularly clean the ice basket, the water tank, the water tray, the freeze fingers
and the ice shovel. Use a damp cloth, maybe with a little mild detergent, to clean
the inside and the outside of the ice cube maker. Rinse thoroughly before using
the appliance again.
• Drain all water from the water tank through the drain hole at the bottom of the ice
cube maker.
• Do not use any chemical products or products containing acids, gasoline or oil.
• Do not use any mechanical appliances or other aids to speed up the freezing
process.
• If the appliance has not been operated for a long time, it might occur that the
ADD WATER indicator light will remain lit. In that case, press the POWER
button to return to the normal state of the appliance.
32