Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Select Location
The proper location will ensure peak performance of your ap-
pliance. We recommend a location where the unit will be out
of direct sunlight and away from heat sources. To assure your
product performs to specifications the recommended installation
location temperature range is from 65 to 90°F (18 to 32°C).
Outdoor Installation
Only the 25OiM model is suitable for outdoor installations.
Building codes may require a ground fault circuit interrupter
electrical receptacle to supply electrical power to the refrigerator
for outdoor applications, (see "Electrical Connection" section).
Do not install in a location where the unit will be exposed to
direct sun exposure as this may result in unsatisfactory perfor-
mance.
Winterizing your Outdoor Ice Maker
In colder climates the ice maker will need to be winterized. The
water fill valve needs to be disconnected from the water supply
line. The water fill line from the bottom of the water fill valve will
also need to be disconnected and drained.
With the fill valve disconnected and the fill line drained, leave
the ice maker running and allow the unit to dump one last time
to remove any ice from the trays.
If the unit is to be sitting for a prolonged period of time not run-
ning, it is advisable to dry out the tray with paper towels.
Cabinet Clearance
Ventilation is required from the bottom front section of the unit.
Keep this area open and clear of any obstructions. Adjacent
cabinets and counter top can be installed around the unit as long
as the front grille remains unobstructed.
INSTALLING YOUR ICE MACHINE
Front Grille
Do not obstruct the front grille. The openings within the front
grille allow air to flow through the condenser heat exchanger.
Restrictions to this air flow will result in increased energy usage
and loss of cooling capacity. For this reason it is important this
area to not be obstructed and the grille openings kept clean.
AGA MARVEL does not recommend the use of custom made
grilles as air flow may be restricted because of inadequate open-
ings. (See Figure 2).
4
Front
Leveling Legs
Figure 2
Front Grille, keep
this area open.
Rear
Leveling legs
Publicité
Chapitres
Table des Matières
