AGA MARVEL 15iM Instructions D'installation, D'utilisation Et D'entretien page 14

Step 8: Assemble the lock parts
Two (2) lock extensions are supplied with the lock. Use the
longer extension for a 3/4" thick overlay panel and the shorter
one for a 5/8" thick panel. Assemble the lock extension, cam stop
washer, spring washer, and set screw to the lock as shown in
Figure 12 and 13.
Install this assembly into the overlay panel and secure with the
retaining nut using a 15mm socket. Make sure the key slot in the
lock is vertical.
BRASS EXTENSION
SPRING WASHER
NUT
LOCK
15/32 HOLE
13/16 COUNTER
BORE 7/16 DEEP
3/4 INCH
WOOD PANEL
Step 9: Secure overlay panel to the door.
With the #10 wood screws provided, fasten the overlay panel to
the door. (See Figure 15).
Step 10: Install lock cam (Models with locks only).
Attach the lock cam to the back of the lock assembly with the
phillips head machine screw provided. Orient the lock cam verti-
cally when installing on the lock.
Step 11: Install door gasket
Press the door gasket into the door channel. Make certain the
gasket corners are fully inserted. If applicable insert the key into
the lock and make certain the lock operates properly.
Step 12: Install the door
Install the top and bottom hinge adapter bushings back into the
hinge adapters that were removed in step 6. Install the door by
reversing the procedure from step 2. Install the top hinge pin so
the screw head is flush with the top surface of the hinge. If appli-
cable insert key into lock and verify the lock cam works properly
with the catch bracket on the front of the ice machine cabinet.
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
CAM
PHILLIPS SCREW
SECTION A-A
SCALE 1 : 1
Figure 13
Top hinge pin
Top door hinge
adapter
Top hinge adapter
bushing
Bottom door
hinge adapter
Bottom hinge
adapter bushing
Bottom hinge
cam
Bottom hinge pin
INNER
DOOR
Clearance hole through
door gasket channel
#10 Wood Screw
Back of door
14
Figure 14
Right hand
hinges shown
Figure 15
Top hinge
Bottom
hinge