AGA MARVEL 15iM Instructions D'installation, D'utilisation Et D'entretien page 17

Problem
Unit too warm or too cold inside.
Noise or Vibration
Unit will not run.
Moisture collects on outside surface of
cabinet.
Moisture collects on inside of the unit.
TROUBLESHOOTING YOUR ICE MACHINE
Possible Cause
• Control set too warm or cold
• Content temperature not stabilized.
• Excessive usage or prolonged door
openings.
• Airflow to front grille blocked.
• Door gasket not sealing properly.
• Unit not level
• Water line tubing vibration.
• Unit turned off
• Power cord not plugged in.
• No power at outlet.
• Hot and humid conditions.
• Too many door openings.
• Prolonged door openings.
• Hot and humid conditions
•
•
•
•
•
•
•
•
•
•
•
•
•
17
Remedy
Adjust temperature colder or warmer
as required. Allow 24 hours for tem-
perature to stabilize.
Allow temperature to stabilize for at
least 24 hours.
Airflow must not be obstructed to
front grille. See "clearances" on
page 4.
Check door alignment and/or adjust
or replace door gasket..
Level unit, see "Leveling Legs" on
page 4.
Adjust the tubing as necessary to
eliminate unwanted vibrations.
Turn unit on. See "Set the tempera-
ture control" on page 7.
Plug in power cord.
Check house circuit.
Extremely hot and humid conditions
can cause condensation on outside of
the cabinet. As humidity and/or tem-
perature decreases, the condensation
will disappear.
Limit the amount of door openings.
Limit the amount of time with the
door open.
Extreme hot and humid conditions.
Move unit to a controlled environ-
ment.