Burner Tubes - England's Stove Works 15-W08 Guide D'installation Et D'utilisation

Burner tube replacement
There are three different burner tubes in the top of the stove. To replace a tube, first
be sure that you order the correct tube you need to replace. Then using a 5/16" socket or
open end wrench, remove the screw located on the left side of the tube. Be sure to keep the
screw. Push the tube to the right then remove the tube (pulling the tube back to the left
after that side has been removed from the hole). To replace, reverse the above
procedure...make sure to install the tubes in the correct order. (Front to Back)
Ceramic fiberboard replacement
There are four fiber boards
located in the top of this stove, in
two layers. While the bottom layer is
oriented 'North/South' as shown, the
top layer is oriented 'East/West'. To
replace a cracked or broken board,
first remove the front burner
tube. Then remove the board you
need to replace. Install the new
board (the boards should sit flush
together side by side). Replace the
tube previously removed.
Dog box replacement
See Brick Layout (page 34) for dog box location in the firebox.
To replace the dog box, first remove the ash pan. Then remove the two 9/16"
nuts that hold the carriage bolts in place. Open the front door of the stove and lift up
on the dog box. Install new or existing carriage bolts into the holes on the flange of the
dog box and re‐install in the reverse manner in which it was removed.
Heat shield removal
There are two 5/16" screws that are on the rear of the heat shield. To remove the heat
shield, using a 5/16" socket or open ended wrench, remove the two screws. Then pull the heat
shield up and back off the back panel.
25
REPLACING COMPONENTS
Burner Tubes
Fiber Boards
(white)