sangiorgio EES510 Serie Manuel D'utilisation Et D'entretien page 126

problem
The machine does not turn on
or start
The machine turns on but
does not start and LEDs No.
1 and 2 flash (LED model) or
F1 appears on display (LCD
model) .
The machine does not take
water and LEDs. 1 and 3 flash
(LED model) or F2 appears
on display (LCD model) .
Led number 2 and 3 flash
(LED model) or F3 appears
on monitor (Display model).
The machine does not empty,
does not spin and leds 1 and
4 flash (LED model) or F4 ap-
pears on display (LCD model)
Leds number 2 and 4 flash
(LED model) or F5 is dis-
played (Display model).
Leds number 1, 2 and 4 flash
(LED model) or F6 is dis-
played (Display model).
The door does not open
30
lED lcD
possible solution
alarm alarm
o
o
F1
●
●
o
●
o F2
●
o
●
F3
●
o
●
o
o F4
●
●
o
F5
●
o
●
o
F6
●
●
• Make sure that the power plug is inserted.
• Make sure there is power in the socket.
• Make sure that the selector switch, pro-
gramme selector knob 1, is not in the OFF
position.
• Make sure the door is well closed
• Make sure there is water supply.
• Make sure the water tap is opened.
• Make sure the water inlet hose is not
squashed.
• Make the water electro-valve filter is not
clogged
• Switch off and then switch on the wash-
ing machine. In the fault persist contact an
authorised service centre.
• Make sure the drain pump filter is not
clogged. See page 22.
• Make sure the rinse hold special function
is enabled.
• Make sure that the drain hose is not
squashed and the internal diameter of
the drainage is larger the that of the drain
hose.
• Switch off and then switch on the wash-
ing machine. In the fault persist contact an
authorised service centre.
• Switch off and then switch on the wash-
ing machine. In the fault persist contact an
authorised service centre.
• Make sure the red pilot lamp turns off.
• Make the special function SOAK or RINSE
HOLD is not activated
• Push the door from the door locking side
or give a slight tap and at the same time
pool it to open.