Water Drainage; Power Supply Connection - sangiorgio EES510 Serie Manuel D'utilisation Et D'entretien

WatEr DrainagE

Drain hose can be installed in two different
ways:
- on the edge of sink using the plastic hose
hanger commercially available.
Figure 6
In this case make sure that the tube is secured
to the sink.
- in a drain pipe at a height of not less than
60 cm and not more than 90cm.
The tube end must always be ventilated, i.e. the
inside diameter of the drain pipe must be larger
than the outer diameter of the drain hose of the
washing machine. The drain hose must not be
obstructed.
Figure 7
n.b. it is not recommend using extension
on the drain hose.
liQuiD DEtErgEnt bulkHEaD pan
Inside the kit supplied, there is a bulkhead pan
of blue colour which grants the use of liquid
detergents in the washing machine.
To install a bulkhead it is necessary to:
• remove the detergent drawer from the
washing machine
• apply the bulkhead as shown in photo
After installation, replace the drawer into the
washing machine. There is no need to remove
the bulkhead (see p. 19).

power supply connection

The machine is equipped with a
connecting cable and earthed
schuko plug for connection to
AC 230 V ~ 50 Hz
Make sure the schuko plug is al-
ways accessible to unplug the
machine from the mains. The
electrical power system must
be designed according to VDE
0100.
It is recommend to not connect
in any case the machine with
extension cords multiple pow-
er sockets, etc to avoid over-
heating which are sources of
potential fire hazard. The man-
.
13
EN