Prewash And Soak; Start/Pause; Delayed Start And Child Safety Display Model Only; Door Lock Led - sangiorgio EES510 Serie Manuel D'utilisation Et D'entretien

5. prEWasH anD soak

This key allows for the selection of prewash
or soak function. Upon each press of the but-
ton the LED indicator changes state There are
three possible combinations which are:
Led steadily on - prewash
Led blinking - soak
Led off - exclusion of both
The prewash function is used to make a low
temperature washing before the main wash cy-
cle to remove stains.
The soak function is used to soak laundry be-
fore main wash cycle.

6. start/pausE

The button activates and deactivates the se-
lected washing programme.
7. DElaYED start anD cHilD
safEtY DisplaY moDEl onlY
This button, when selecting a washing pro-
gramme, it allows for the adjustment of the de-
lay start function; while after starting the wash
cycle it allows for the activation of the child
safety locking feature.
To set the delayed start time the button is
pressed repeatedly until the desired value
shown on the digit display. The value can be
chosen between 1 and 24 hours.
Pressing the Start/Pause button the countdown
starts on until the expiration of the time on the
digit display.
To set the child lock, after the starting of the
wash cycle, press and hold the button P7 until
the red LED of the "Door Lock" begins to flash.
To disable this feature, press and hold the but-
ton until the red LED stops flashing. "Locked
Door" lamp becomes stable.

Door lock lED

This LED, red in colour, indicates the locking of
the door which can be opened only after it turns
itself off.

first usE

before the regular use it is necessary to
make a wash cycle with detergent, no laun-
dry and setting the temperature to 60°c with
cotton programme.
Now the machine is ready for use, proceed as
follows:
Load the laundry, taking care to select it.
Close the door, taking care not to leave laundry
protruding from the seal, see figure page 11.
1) Selection of wash programme.
Customize the washing programme adjusting
the spin, temperature and choosing any options
for the programme selected.
Press the start button; the program starts when
the LED red coloured is on. Any variations to
be made to temperature, spin and special func-
tions can also be performed during the execu-
tion of the programme, obviously before the
beginning of the heating and spinning phases.
Also after the beginning of the programme the
soak, extra rinse or rinse hold can be enabled.
EN
17