Installation Under A Work Plain; Water Supply Connection - sangiorgio EES510 Serie Manuel D'utilisation Et D'entretien

After adjustment, to avoid their modification by
vibrations, they should tighten by the ring nut
and/or nut on the foot until it locks as shown in
the figure below.
Figure 3b
Cabinet
Nut
Adjustable Foot
It is good to avoid, at any case, placing under
or around to the machine cardboard, wood
or similar materials, so as not to obstruct the
passage of air.

installation unDEr a Work plain

The positioning of the machine under a
work plan, can only happen if the housing
compartment has the following dimensions of
width of 76cm and of height of 85cm. It should
also be considered that the machine needs a
approximately 5cm behind from the wall. An
example of a typical installation is shown in the
illustration below. The superior cover (TOP) of
the machine must not be removed for reasons
of electrical and mechanical safety.
Figure 4
12

WatEr supplY connEction

The water inlet hose must be connected to a
tap of cold water with a 3/4" threaded mouth.
Use only the supplied water inlet hose, avoiding
the use of old hoses, or hoses used previously.
n.b. the hose is already complete with
rubber gasket, if this is missing, the tube
must not be used.
If the water supply system is new or has been
inactive for too long, it will be necessary to
allow the water run until the water appears
clear before connecting the hose.
Figure 5
Figure 5b shows the connection to the hot water
tap, this option is only available on request.
Figure 5b
Hot water
Make sure that the domestic hot water supply
temperature does not exceed 55°C to avoid
damage to the laundry and washing machine.
For the inlet hose only use the supplied.
Cold water