WAGNER FURNO 500 Guide D'utilisation page 9

Carry Case (optional) (Fig. 7)
The heat gun case has been specifically
designed to secure the heat gun in the
upright position for work on uneven surfaces
(see AngleLoc, below).
angleLoc™ (Fig. 8)
a: Insert the back of the heat gun so that the rear stabilizing fins locate themselves below
the ridges on the side wall of the cavity in the top of the carry case.
B: Then slide the heat gun forward so that it naturally locks into place at a 135 degree
angle. The heat gun should now be secure for upright use.
8a
Note: always set the heat gun upright after it is turned off, either for a short break
or for storage. avoid laying the unit on the side after shutdown. The heat will
remain in the unit and cooling will take longer. Store the unit only after the
nozzle is cool. Unplug the unit before storing to prevent accidental startup.
Many variables affect heating applications, such as the material being heated, ambient
temperature, the distance from the gun to the substrate and the heating technique. For this
reason, Wagner has provided temperature guidelines for certain applications. Always start the
heat gun at the lowest temperature in the range then raise the temperature until the optimum
temperature is achieved. Always keep the heat gun in motion and at least 2" from the substrate
when applying heat.
For more details on multiple projects and 'how to' videos please visit our website -
www.wagnerspraytech.com.
IMPOrTaNT: always protect glass when working near windows.
do not touch nozzle or the scraper blade when working. These become
extremely hot and will cause severe burns. Wear gloves to protect hands from
hot scrapings.
7
8b
9
EN