WAGNER FURNO 500 Guide D'utilisation page 8

Cool down Mode (Fig. 6)
While the heat gun is operating, press the
power button once to enter cool down
mode. When cool down mode is entered, the
gun will run for 3 minutes with maximum
air flow. During this period, the temperature
bars will all flash and step down to indicate
cooling. To override cool down mode, press
and hold the power button for 2-3s.
Startup
1. Plug the unit into a standard wall outlet.
2. Turn on the heat gun by pressing the power button on the Control Panel (Fig. 4, 1). When
the gun is turned on, it is automatically set in the low temperature range (Fig. 5, a) at
150ºF and a low air flow setting.
3. If you wish to continue working within the low temperature range, simply press the plus
or minus button on the touch pad until your desired temperature setting is selected, this
will be indicated by the temperature bar being lit.
4. If you wish to operate within the high temperature range and high air flow setting, press
the Mode Selector button (Fig. 4, 2) once. The high temperature range indicator light will
turn on. You can now simply press the plus or minus button on the touch pad until you
reach your desired temperature setting, this will be indicated by the temperature bar
being lit.
IMPOrTaNT: If the blower motor in the heat gun does not turn on when the POWer
button is activated, turn the switch OFF immediately. The heating element will burn out if
it is not cooled by the blower.
5. During rest periods or when you are finished with your project, press the power button
to enter cool down mode. The blue cool down indicator light will turn on and the gun
will continue to run with the element disabled, so that cooling occurs.
6. Set the gun down in an upright position. The heat gun will shut itself off after 30 seconds.
Following cool down mode the barrel of the heat gun may still be hot.
Note: Smoke may appear during the initial start up due to the burning of
manufacturing oils. The smoke should disappear in less than a minute.
8
EN
6