Dismantling (B); Converting (C) - Asko HG1666AB Installation

CONVERSION INSTRUCTION

Dismantling (B)

Converting (C)

Contents of conversion set:
• Injectors for the burners (see illustration A1, at the back of this
instruction);
• Simmer setting screws for the gas taps;
• Gaskets;
• Three data labels with the modified gas setting;
• Fiber rings for enamelled appliances;
• Silicon sealing plugs.
Please note: disconnect the appliance from the power supply before
you remove the drip tray. Prevent damage of the worktop. Lay down
parts of the appliance on a protected base.
1. Remove the pan supports, burner heads and burner cups.
Pull off the control knobs vertically and remove them.
2. Loosen the screws of the mounting brackets at the underside of the
appliance (see illustration B1, at the back of this instruction).
3. Unscrew the screws that are holding the burners (see illustration B2,
at the back of this instruction).
4. Lift the drip tray on the back of the appliance, dismount the earth
wire (if applicable), and slide the drip tray to the front (see illustration
B3, at the back of this instruction).
5. Remove the drip tray.
For verification, you can find the values of the injector and simmer setting
screws on the holder of the injectors. The characters of the sets correspond
with the characters on the label inside the lower tray of the appliance (upper
case characters for injectors and lower case characters for simmer setting
screws). The values are also indicated on the injectors and simmer setting
screws (see table 1, at the back of this instruction).
The following sets can occur:
• Set 'A-a' for auxiliary burner;
• Set 'B-b' for semi rapid burner;
• Set 'C-c' for rapid burner;
• 'H1-h', 'H2' and 'J-j' sets for wok burner.
It is possible that not all the injectors in the set will be used for the
conversion of your appliance.
EN 5