Introduction (A) - Asko HG1666AB Installation

CONVERSION INSTRUCTION

Introduction (A)

EN 4
Attention: Performing of these instructions by a non-qualified
engineer can lead to dangerous situations
The supplier is not responsible for the consequences (the arising of
a hazardous situation and/or damage to persons or goods) caused
by incorrect performance of these instructions by engineers who are
not employees of the supplier. Consequential damage arising through
inexpert performance of these instructions is not accepted.
This conversion-set consists of original parts. Original parts are tested for
suitability and safety during the type approval of the appliance. Frequently
performed batch-approvals guarantee the quality of original parts.
The supplier recommends, when converting an appliance to another gas
type, to have this performed by an engineer of the service department.
Contact the supplier to make an appointment with a service engineer.
For addresses see the guarantee regulations of the appliance.
With this conversion-set you can convert your gas hob from natural gas
(G20/ G25) to propane/butane gas. Before you start conversion, check
whether your gas hob is genuinely set to natural gas.
Tools
A. Socket spanner
7
B. Screw driver flat blade
4
C. Screw driver Torx
T20
D. Screw driver cross head
P2
E. Nose pliers
F. Open end spanner
7
G. Leakage test spray