English; Getting Started - Braun Satin-Hair 7 ST 710 Mode D'emploi

2
D
I
Das Gerät darf am Ende seiner Lebensdauer nicht mit
dem Hausmüll entsorgt werden. Die Entsorgung kann
über den Braun Kundendienst oder lokal verfügbare
Rückgabe- und Sammelstellen erfolgen.
Garantie
Als Hersteller übernehmen wir für dieses Gerät – nach Wahl
des Käufers zusätzlich zu den gesetzlichen Gewährleistungs-
ansprüchen gegen den Verkäufer – eine Garantie von 2 Jahren
ab Kaufdatum. Innerhalb dieser Garantiezeit beseitigen wir nach
unserer Wahl durch Reparatur oder Austausch des Gerätes
unentgeltlich alle Mängel, die auf Material- oder Herstellungs-
fehlern beruhen. Die Garantie kann in allen Ländern in Anspruch
genommen werden, in denen dieses Braun Gerät von uns
autorisiert verkauft wird.
Von der Garantie sind ausgenommen: Schäden durch unsach-
gemäßen Gebrauch, normaler Verschleiß und Verbrauch sowie
Mängel, die den Wert oder die Gebrauchstauglichkeit des Gerätes
nur unerheblich beeinflussen. Bei Eingriffen durch nicht von uns
autorisierte Braun Kundendienstpartner sowie bei Verwendung
anderer als Original Braun Ersatzteile erlischt die Garantie.
Im Garantiefall senden Sie das Gerät mit Kaufbeleg bitte an
einen autorisierten Braun Kundendienstpartner. Die Anschrift
finden Sie unter www.service.braun.com oder können Sie
kostenlos unter 00800/27 28 64 63 erfragen.

English

Please read these use instructions carefully before use and keep
them for future reference.
Important
• Plug your appliance into an alternating current outlet only and
make sure that your household voltage corresponds to the
voltage printed on the appliance.
• This appliance must never be used near water (e.g. a filled
wash basin, bathtub or shower). Do not allow the
appliance to get wet.
• For additional protection, it is advisable to install a residual
current device (RCD) with a rated residual operating current
not exceeding 30 mA in the electrical circuit of your bathroom.
Ask your installer for advice.
• This appliance is not intended for use by children or persons
with reduced physical, sensory or mental capabilities, unless
they are given supervision by a person responsible for their
safety. In general, we recommend that you keep the appliance
out of reach of children. Children should be supervised to
ensure that they do not play with the appliance.
• Avoid touching the hot parts of the appliance.
• When hot, do not place on surfaces that are not heat-resistant.
• Do not wrap the mains cord around the appliance. Regularly
check the mains cord for wear or damage. If the cord is dam-
aged, stop using the appliance and take it to an authorized
Braun Service Centre. Unqualified repair work can lead to
extreme hazards for the user.
• The appliance should be used on dry hair only.
• Be careful when using the appliance at maximum temperature. Be careful when using the appliance at maximum temperature.
Description
1 Cool touch
2 Display
3 Temperature selection buttons ( – / + )
4 «°C max» button (for instant high-temperature styling)
5 «satin ions» button
6 «on/off» button
7 Swivel cord (2 m length)
8 Green ion jets
9 NanoGlide Styling plates
IONTEC
IONTEC is a technology which is specifically developed to
protect the health of your hair. It restores the moisture balance of
your hair that usually gets lost during styling with excessive heat.
By activating the «satin ions» button (5), the green ion jets (8)
release millions of ions effectively on to your hair. These satin
ions envelop every single hair and quickly restore the moisture
balance of your hair by attracting moisture particles from the air
while straightening. The display now shows «satin ions» [C] and
a slight crackling noise can be heard.

Getting started

• Connect the appliance to an electrical outlet and push the
«on/off» button (6) for 1 second to turn it on.
• During heat-up, the display turns red. The appliance is
delivered with a default temperature setting of 160 °C. The
thermometer symbol is flashing as long as the displayed
temperature is not reached. [A]
• After approx. 30 seconds, the display turns green indicating
that the minimum styling temperature is reached. You can start
using the appliance.
• As soon as the preset temperature is reached, the thermometer
symbol stops flashing [B].
• Individual temperature choice: Using the temperature selection
buttons (3), you can adjust the temperature in 5 °C steps in a
range between 130 °C and 200 °C. We recommend the
following temperature settings:
Hair structure
Fine, porous, coloured, bleached
Normal
Strong, resistant
. . . and for professional styling results
The higher the temperature setting, the faster you will get a
sleek straightening result. When working with the maximum
temperature setting, you should not treat the same strand
more than once.
• °C max booster: For handling difficult hair strands, you can
instantly boost the temperature by pushing the «°C max»
button (4). For 20 seconds, the appliance will heat up to the
maximum temperature with the backlight flashing [D].
Afterwards, the appliance switches back to the previously
selected temperature.
• Safety auto off: For safety reasons, the appliance automatically
switches off after 30 minutes. Five minutes prior to switching
off, the display shows «Auto off» [E] along with a red/green
flashing backlight. If you want to keep on straightening, simply
press the «on/off» button (6) again shortly.
• Memory function: In order to make your styling session as
convenient and quick as possible, the appliance stores your
last personalised settings for the next usage.
Styling
Preparation
• Make sure your hair is completely dry before using the
appliance.
• First, comb your hair through with a wide toothed comb to
remove tangles [G].
• Section your hair off. Starting close to the roots, take a thin
section of hair (strands of 3–4 cm maximum) and clamp it
firmly between the styling plates [H].
How to straighten your hair
• Gently run the straightener through the entire length of the hair,
slowly and steadily, from roots to the ends [I] without stopping
for longer than 2 seconds. This will ensure best straightening
results without damaging your hair. Since the NanoGlide
Ceramic plates are 3 times smoother than conventional
ceramic plates, they protect your hair from damage by
providing friction-free gliding.
• For improved control when gliding along a strand, you may
stabilise the appliance by holding it with the other hand on the
cool touch points (1).
• You can create flicks at the hair ends by slowly turning the
appliance either outwards or inwards before releasing a strand.
How to form curls
With the Braun straightener, you can also create loose curls and
waves [J]:
3
3 4 5 6
E
Auto off
F
Temperature setting
130 °C – 160 °C
160 °C – 175 °C
175 °C – 200 °C