Adjusting The Sound - JVC KD-AR560 Manuel D'instructions

Adjusting the sound

You can adjust the sound characteristics to your
preference.
1
1
* For KD-G510: Displayed only when
"L/O MODE" is set to "WOOFER"
(see page 21).
Ex.: When "TRE" is selected
2
Indication pattern changes as
you adjust the level.
Indication To do:
BAS* Adjust the bass.
2
(bass)
TRE* 2 Adjust the treble.
(treble)
FAD* 3, * 7 Adjust the front
(fader) and rear speaker
balance.
BAL* 7 Adjust the left
(balance) and right speaker
balance.
LOUD* 2 Boost low and
(loudness) high frequencies
to produce a well-
balanced sound at
low volume level.
SUB. W* 4 Adjust the
(subwoofer) subwoofer output
level.
VOL* Adjust the
5
(volume) volume.
2
* When you adjust the bass, treble, or
loudness, the adjustment you have made is
stored for the currently selected sound mode
(C-EQ) including "USER."
3
* If you are using a two-speaker system, set
the fader level to "00."
4
* This takes effect only when a subwoofer is
connected.
5
* Normally the control dial works as the
volume control. So you do not have to select
"VOL" to adjust the volume level.
6
* Depending on the amplifier gain control
setting. (See page 22 for details.)
7
* This adjustment cannot affect the subwoofer
output.
Range
–06 (min.)
to
+06 (max.)
–06 (min.)
to
+06 (max.)
R06 (Rear
only)
to
F06 (Front
only)
L06 (Left
only)
to
R06 (Right
only)
LOUD ON
J
LOUD
OFF
00 (min.)
to
08 (max.)
00 (min.)
to
30 or 50
(max.)* 6
19