Cv Table For Fx (Mm) - Marklin Digital 60975 Mode D'emploi

CV Explanation
1 Address 1 (main address)
2
Minimum speed (Vmin)
3 Acceleration delay (AV)
4
Braking delay (BV)
5 Maximum speed (Vmax)
7
Automatic Calibration
8 Decoder reset (default or factory setting)
17 Address 3 (2nd consecutive address)
18
Address 4 (3rd consecutive address)
Braking mode:
Bit 0 - 3 : always 0,
Bit 4 : DC voltage, polarity against the
27
direction of travel
Bit 5 : DC voltage, polarity with the direction
of travel
Bit 6 - 7 : always
* () = 6021 Control Unit {} = the values entered are multiplied times "x" (factor).
38

CV Table for fx (MM)

Values Default
60975=78
1-255 (1 - 80)* 60976=72
60977=24
4
1-255 (1 - 80)*
1-255 (1 - 80)* 12
12
1-255 (1 - 80)*
1-255 (1 - 63)*
180
{x4}*
77
8
1-255 (1 - 80)* 254
253
1-255 (1 - 80)*
0 - 48
0
16
48
32
0
Notes
Address is always active and is not subject
to CV 49..
Speed at the smallest speed level. Value
must be smaller than Vmax, CV 5.
CV value multiplied by 0.25 gives the time
from complete stop to maximum speed.
CV value multiplied by 0.25 gives the time
from Maximum speed to complete stop.
Speed at the highest speed level. Value must
be greater than CV 2.
Enter Value 77. Value 77 is not stored
continuously.
Value is not written.
Address can be deactivated/activated
subject to CV 49.
Address can be deactivated/activated
subject to CV 49.
Braking subject to direction:
- 16 normal DCC properties
- 32 inverse DCC properties
Braking not subject to direction:
- 48: fx/mfx properties