Publicité
Les langues disponibles
Les langues disponibles
and on the Internet (see Physical Functions for the address).
We recommend that in general programming should be done on
the programming track.
Physical Functions
Each of these functions must be connected externally to the cir-
cuit board. We therefore speak of physical functions. A unique
mode/effect can be assigned to each physical output (AUX /
lights) in digital operation. Four CVs are available for each output
for this purpose. Only one mode/effect can be set for each out-
put. A complete table for this can be found on the Internet at:
www.maerklin.de/en -> Service -> Technical Information
Logic Functions
Since these functions are only executed by software, no
physical output is required for them. We therefore speak here of
a logic function.
Acceleration/Braking Delay
• The acceleration and braking time can be set separately from
each other.
• The logic function ABV can be assigned to any function
button by using the function mapping.
Switching Range (RG)
• The switching range causes a reduction in the current speed
of the locomotive. This allows a fine touch in the controlling
the locomotive. The switching range can be assigned in mfx
and DCC to any function button by using the function mapping
(see CV 145, page 45).
Opening Doors / Closing Doors
The locomotive does not start running as long as the function
"opening doors / closing doors" is active. The locomotive starts
accelerating according to the ABV that has been set/activated
only when the function has been deactivated and the sound has
ended.
Station Announcement
The locomotive does not go until after the announcement has
ended.
Decoder functions and CV settings
The following pages have the functions and the CVs presented in
tabular form. These CVs can be given a number of settings and
can be assigned to a number of function buttons.
You will find the CVs and their applications for the fx (MM) and
DCC protocols in separate tables.
In the mfx protocol, you can set the CVs with ease by means of
the display for the CS 2 (Software Version 4.0 and higher) / CS 3.
You or your dealer may have to install an update on your
60213/60214/60215 Central Station.
33
Publicité
Chapitres
