Tripp-Lite PDU Manuel Du Propriétaire page 7

Features
A
200912032 93-2721.indd 7
continued
Cord Retention Bracket: Provides secure attachment points for
connected equipment cords.
Mounting Brackets: Use these brackets to mount the PDU .
SNMP Reset Button: Press the reset button
reboot the PDU's network card. Rebooting the network card will
not erase network settings or interrupt AC power.
A
Factory Port: The port is reserved for configuration by factory
authorized personnel only. Do not connect anything to the port.
PS/2 Port: Use this port to connect a Tripp Lite ENVIROSENSE
environmental sensor to provide remote temperature/humidity
monitoring and a dry contact interface to control and monitor
alarm, security and telecom devices. Contact Tripp Lite Customer
Support at (773) 869-1234 for ordering information. Note: Do not
connect a keyboard or mouse to this port.
Mini-DIN Serial Port: Use this port to provide a direct terminal
connection to a computer with a terminal emulation program. A
serial cable (part number 73-1025) is included with the PDU. If
you need to order a replacement cable, contact Tripp Lite
Customer Support at (773) 869-1234.
Ethernet Port: Use this RJ-45 jack to connect the PDU to the
network with a standard Ethernet patch cable. The Link LED
and Status LED
in the table below. This port is not compatible with PoE (Power
B
Over Ethernet) applications.
Link LED Color
A
Off
Flashing Amber
Flashing Green
Status LED Color
B
Off
Steady Green
Flashing Amber
indicate several operating conditions, as shown
B
Network Operating Conditions
No Network Connection
100 Mbps Network Connection
10 Mbps Network Connection
Card Not Initialized
Card Initialized and Operational
Error - Card Not Initialized
7
for 3 seconds to
A
A
12/17/2009 11:03:17 AM