Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
start the cut from above(Y) about 1/3 of the
diameter into the log (overbuck) and then
finish the cut (Z) from below, in order to avoid
contact of the chain saw with the ground.
When sawing logs supported on only one
end, start the cut from below (Y) about 1/3
of the diameter into the log(underbuck) and
finish the cut from above (Z) in order to avoid
log splitting or jamming of the chain saw.
SAW MAINTENANCE AND
KICKBACK SAFETY
Follow maintenance instructions in this
manual. Proper cleaning of saw and chain and
guide bar maintenance can reduce chances of
kickback. Inspect and maintain saw after each
use. This will increase the service life of your
saw.
NOTE: Even with proper sharpening, risk of
kickback can increase with each sharpening.
MAINTENANCE AND
STORAGE OF CHAIN SAW
If the replacement of the supply cord is
necessary, this has to be done by the
manufacturer or his agent in order to avoid a
safety hazard .
1. Unplug chain saw from power source
•
When not in use
•
Before moving from one place to another
•
Before servicing
•
Before changing accessories or
attachments, such as saw chain and guard
2. Inspect chain saw before and after
each use.
Check saw closely if guard or other part
has been damaged. Check for any damage
that may affect operator safety or operation
of saw. Check for alignment or binding of
moving parts. Check for broken or damaged
parts. Do not use chain saw if damage affects
safety or operation. Have damage repaired
by authorized service center. To locate an
authorized service center, visit
www.worx.com.
Electric Chain Saw
3. Maintain chain saw with care.
•
Never expose saw to rain or direct
moisture.
•
Keep chain sharp, clean, and lubricated for
better and safer performance.
•
Follow steps outlined in this manual to
sharpen chain.
•
Keep handles dry, clean, and free of oil and
grease.
•
Keep all screws and nuts tight.
•
Inspect power cord often. If damaged,
have repaired by authorized service center.
•
Never carry chain saw by power cord.
•
Never yank power cord to unplug it.
•
Keep power cord from heat, oil, and sharp
edges.
•
Inspect extension cords often and replace
if damaged.
4. When servicing, use only identical
replacement parts.
5. When not in use, always store chain
saw
•
In a high or locked place, out of children's
reach
•
In a dry place
•
With bar and chain cover (11) in place
Bar Maintenance
To maximize bar life, the following bar
maintenance is recommended.
The bar rails that carry the chain should be
cleaned before storing the tool or if the bar or
chain appear to be dirty.
The rails should be cleaned every time the
chain is removed.
To clean the Bar rails:
1. Remove chain cover and bar and chain.
(see section ASSEMBLY)
2. Using a wire brush, screwdriver or similar
tool, clear the residue from the inner
groove of the bar (See Fig. M).
3. Make sure to clean oil passages
thoroughly
Conditions which require Chain (8) and
guide bar maintenance:
•
Saw cuts to one side or at an angle.
17
EN
Publicité
Table des Matières
