Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SAW MAInTenAnCe AnD
KICKBACK SAfeTy
Follow maintenance instructions in this
manual. Proper cleaning of saw and chain and
guide bar maintenance can reduce chances of
kickback. Inspect and maintain saw after each
use. This will increase the service life of your
saw.
NoTE: Even with proper sharpening, risk of
kickback can increase with each sharpening.
MAInTenAnCe AnD
STORAGe Of JAWSAW
1. Unplug the JawSaw from power source:
•
When not in use.
•
When transporting.
•
When left unattended.
•
Before servicing.
•
Before fitting the extension pole.
•
Before cleaning.
•
Before changing accessories or
attachments, such as saw chain and
guard.
2. Inspect the saw before and after each use
for:
22
22
•
Any signs of damage, especially the
power cord.
•
Smooth action of push handle and
movement of bar.
•
Adequate chain tension.
•
Adequate chain lubrication.
3. Do not use the JawSaw, if:
•
The trigger switch or lockout is
malfunctioning.
•
The push handle does not smoothly
return under spring force.
•
Any other damage which affects the safety
or operation is evident.
4. Maintain the JawSaw with care and have
any damage or malfunction repaired by
an authorized service center (contact
1-866-354-9679):
•
Never expose the JawSaw to rain.
•
Keep chain sharp, clean, and lubricated
for better and safer performance.
•
Follow steps outlined in this manual to
sharpen chain.
Guarded electric chain saw
•
Keep handles clean and free from oil.
•
Keep all screws and nuts tight.
•
Never carry the JawSaw by the power
cord.
•
Never yank the power cord to unplug it.
•
Keep power cord away from heat, oil and
sharp edges.
•
Inspect extension cords and do not use if
damaged.
5. When servicing, use only identical
replacement parts.
6. When not in use, always store JawSaw
•
In a high or locked place, out of children's
reach.
•
In a dry place.
rEPLAciNG SAw chAiN/chAiN bAr
Replace chain when cutters are too worn
to sharpen or when chain breaks. Only use
replacement chain noted in this manual.
Always include new drive sprocket when
replacing chain. This will maintain proper
driving of chain. Inspect guide bar before
sharpening chain. A worn or damaged guide
bar is unsafe. A worn or damaged guide bar
will damage chain. It will also make cutting
harder.
To Replace the bar, remove the mounting plate
(a), which is retained by a single screw.
To fit to the new bar, fit the mounting plate
(a) into the new bar by tightening the screw
clockwise. The projecting tab (f) must be fitted
through the bar slots outwards. (See Fig. F&G)
ShArPENiNG SAw chAiN
wArNiNG: unplug JawSaw from
power source before servicing.
Severe injury or death could occur from
electrical shock or body contact with
moving chain.
wArNiNG: cutting edges on chain
are sharp. use protective gloves
when handling chain.
Keep chain sharp. Your saw will cut faster and
more safely. A dull chain will cause undue
sprocket, guide bar, chain, and motor wear. If
you must force chain into wood and cutting
creates only sawdust with few large chips,
chain is dull.
en
Publicité
Table des Matières
