Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
2
3
4
1
1.
120
EN
9
8
7
6
5
2.
2
3.
Product overview
1x
1
Locking knob
2
Auxiliary handle
3
Tool holder
4
Chisel
5
Locking bolt
6
Clamping knob
7
Screw plug for lubricating tank
8
Handle
9
On/ off switch
3x
Intended use
This tool is intended
– for chipping and demolition work in con-
crete, stone and equivalent material.
– only for private use
– to be used according to the descriptions
and safety instructions indicated in this op-
1x
erating manual.
Any other use is not as intended. Improper use
is not covered by the warranty and the manu-
facturer will reject any liability. The user is li-
able for all injuries to third parties and damage
to their property.
DE
Lieferumfang
FR
Etendue de livraison
IT
Materiale compreso nella fornitura
Preparation
NL
Leveringsomvang
SV
HANDLE ASSEMBLY
Leveransomfång
1
Release the clamping knob
6
by turning
CZ
counterclockwise.
Rozsah dodávky
SK
Warning! Make sure the tool is
Rozsah dodávky
switched off and unplugged.
RO
Volumul livrat
GB
Scope of delivery
Using the tool
1x
Warning! Risk of serious injuries.
Do not turn the tool towards your-
self, other people or animals.
1. Follow the instructions in section „Prepa-
ration" („Handle assembly" to „Insert
chisel") before use.
2. Plug the power cord into a suitable wall
socket (see "Technical data", EU plug
(6822596), Swiss plug (10252553).
1x
3. Hold tool firmly with both hands at its
handle
8
and auxiliary handle 2. Stand
securely.
4. To turn on the tool press and hold the on/
off switch 9. The tool will start vibrating.
5. To lock the tool, press the on/ off switch
and press the locking knob 1.
6. Run the hammer unloaded for a few
seconds for lubricating purposes when
the ambient temperature is low or after
2x
breaks.
7.
Set the hammer with the chisel tip onto
the working surface. The chiselling will
start automatically.
8. To switch off the tool, release the on/ off
switch
9.
To release the knocking knob
press the on/ off
9
switch shortly before.
2
Set the desired position of the handle
8
and tighten the clamping knob
6
by
turning it clockwise.
EN
9
1
121
Publicité
Chapitres
Table des Matières
