in-lite SENTINA 150X150 Manuel D'utilisation page 9

EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first. This fixture can
be built into various sorts of decorative paving, such as concrete or
natural stone.
Step 1
Replace a 150 x 150 mm / 5.9 x 5.9 inch stone with this fixture or, in the
case of large, unbroken surfaces, saw out a 150 x 150 mm / 5.9 x 5.9
inch piece. The fixture can then be placed directly on the underlying
sand bed.
Step 2
Join the Easy-Lock connector to the main cable. (Fig. 1)
a. Clamp the cable duct on top of the main cable.
b. Place the cable duct (with the cable at the bottom) in the Easy-
Lock connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 3
Connect the main cable to the fixture by connecting the mini-
connector. (Fig. 2)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 2 and 3. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.