Remote Control 1 - FONESTAR MPZ-6241 Mode D'emploi

EN
12.- SIREN GAIN: control that regulates the volume level of the alarm.
13.- CHIME GAIN: control that regulates the volume level of the CHIMES.
14.- COM: common terminal which activates the warning tone or the alarm via contact closure.
15.- CHIME: contact closure that activates chime sound.
16.- SIREN: contact closure that activates the siren sound.
17.- 24 V DC, 8 A:
24 V DC supply terminals. For amplifier operation with 24 V DC power supply, batteries, emergency
power supply system, etc. Connect with 2.5 mm
terminals.
Note: when using a 24 V DC amplifier, the output power is reduced by approximately 20%.
COM: common connection terminal.
4-16 Ω: output for low impedance loudspeakers 4-16Ω.
70 V/100 V: terminals for connecting loudspeakers with 70 or 100 V line transformer. Connect the
positive terminal of each zone to the corresponding 70 or 100 V terminal and common terminal to the
COM terminal.
18.- AC power socket.
REMOTE CONTROL
1.- : switches the MP3/FM module on/off.
2.- STOP: in playback mode, stops playback.
3.- : mutes the audio output of the MP3/FM module.
4.- MODE: allows you to select between the different operating mode.
5.- : this button allows you to change the playback mode: repeat one track (1), repeat tracks in a
folder (F), repeat all tracks (A) and shuffle (R).
6.- EQ: EQ control: Flat (fla), Classic, Pop, Rock, Jazz and Voice (voc).
7.- / : in playback mode, a short press of these buttons skips to the previous/next song. And a long
press performs a fast rewind/fast forward of the song. In radio mode, one press of these buttons
switches to the previous/next stored station.
8.- : in playback mode, one press of this button starts/pauses playback. In FM mode a short press
allows you to perform an automatic station scan.
9.- / : MP3/FM module volume controls.
10.- 0-9: numeric selection buttons.
section cable to the - negative and + positive
2
1 2 3
STOP
4
EQ
MODE
7
9 0
1 2 3
10 4 5 6
7 8 9
- 4 -
5
6
8