Controls And Functions; Front Panel - FONESTAR MPZ-6241 Mode D'emploi

EN
DESCRIPTION
- Zone Amplifier with 6 output zones with independent volume control, MP3 player, and digital FM tuner.
- Possibility of paging and message playback in zones using microphone with zone selector M-62.
- Suitable for commercial installations consisting of several zones, each equipped with loudspeakers with
piped music and the need to page in the various zones

CONTROLS AND FUNCTIONS

FRONT PANEL

MULTIZONE AMPLIFIER MPZ-6241
INPUT 1
1
1.- INPUT 1: dial that regulates the volume of the corresponding input channel.
2.- TREBLE: high pitch control that regulates the high pitches of the corresponding input channel.
3.- BASS: low pitch control that regulates the bass of the corresponding input channel.
4.- MP3 Module.
1.- Infrared sensor for remote control.
2.- /MODE: short presses of this button allow you to select
between the different operating modes. A long press
MPZ-6241
MULTIZONE AMPLIFIER
switches the MP3/FM module ON/OFF.
3.- Information display.
POWER CONSUMPTION: 320 W
/VOL +: in MP3 playback mode, a short press on these
4.-
buttons skips to the previous song. In radio mode, a short
~ 115 V AC. 50/60 Hz FUSE: T5AL 250 V
~ 230 V AC. 50/60 Hz FUSE: T5AL 250 V
press on these buttons switches to the previous stored FM station.
18
A long press increases the volume of the MP3/FM module.
5.- USB storage device port.
6.- MicroSD memory card connection port.
7.- /VOL -: in MP3 playback mode, a short press on these buttons allows you to skip to the next
song. In radio mode, a short press on these buttons switches to the next stored FM station.
Press and hold to decrease the volume of the MP3/FM module.
8.- : in playback mode, one press of this button starts/pauses playback. In radio mode, one press
enables automatic station search. Pressing the MODE button during recording allows you to end/
save the audio track. In FM mode a short press allows you to perform an automatic station scan.
9.- REC: allows recording of INPUT 1-5 and remote microphone M-46 inputs. Recordings will be
stored on the connected USB device (priority) or microSD card. To start recording select PLAYING
mode and press the REC button. To stop recording, press the MODE button again.
It also allows you to play back previously recorded tracks. Select USB or microSD mode (where the
recordings have been stored) and long press the REC button to start playback of the recordings.
10.- : this button allows you to change the playback mode: repeat one track (1), repeat tracks in a
folder (F), repeat all tracks (A) and shuffle (R).
5.- Activation indicator light for all zones.
6.- Z1: output zone activation/deactivation button.
7.- Output zone activation indicator light.
8.- VOL: output volume control for each zone.
9.- SIG: light indicator for the presence of a general output signal.
4
MODE VOL +
REC
VOL -
BASS BASS BASS
INPUT 2 INPUT 3 INPUT 4
TREBLE TREBLE TREBLE
2 3
ONE ZONE: 50 W MAX.
TOTAL ALL ZONES: 240 W MAX.
CLASS II WIRING
17
5 6 7 8 9
ALL Z1 Z2 Z3
VOL VOL VOL
BASS BASS BASS
INPUT 5 INPUT 6
TREBLE TREBLE TREBLE
1
INPUT 4
CLASS II WIRING
PUSH
CHIME
CHIME SIREN
GAIN GAIN
LINE PHANTOM +48 V
SIREN COM
MIC
16 15 14 13 12
- 2 -
1011 12
13
Z4 Z5 Z6
PROT
VOL VOL VOL
CLIP
SIG
MASTER
17 16
1 2 3
2 3 4 5 6 7 8
MODE
REC INPUT
OUT
MUTE EMC TEL
REMOTE MIC
REC
VOL
INPUT 3 INPUT 2
PUSH PUSH
10 9
LINE PHANTOM +48 V LINE PHANTOM +48 V LINE PHANTOM +48 V
MIC MIC MIC
11
POWER
14
AC
15
DC
4 5 6
9
VOL +
VOL -
INPUT 1
PUSH
8 7
10