Gear System; Front Light - Nilox DOC E-BIKE X3 Mode D'emploi

GEAR SYSTEM

The rear wheel is fitted with Shimano 6-speed gear (dérailleur) shifter.
Its use is identical to the use of traditional bicycle gearing and it is governed by
the classic lever located near the right-hand handlebar.
AS FOR TRADITIONAL BICYCLE GEARING, IT MUST BE USED WITH THE BICYCLE
IN MOTION.

FRONT LIGHT

DOC E-BIKE X3 is equipped with a 5-LED torch powered by common
alkaline batteries.
PEDAL ASSIST (PAS) CONTROL PANEL
The pedal assist (PAS) control unit is located on the left side of the handlebar.
DOC E-BIKE X3 is fitted with switches for pedal assist at three speeds.
THE PEDAL ASSIST FUNCTION CANNOT BE ACTIVATED WITH THE BICYCLE AT A STANDSTILL.
PAS operation:
Pedal and simultaneously activate the PAS. This method entails a greater use of current and a
•
greater wear of the motor.
Pedal until you create a certain inertia for the bicycle, activate the PAS and resume pedalling.
•
This method on the other hand allows greater savings in current and therefore a greater
protection of the motor.
• Cycle while avoiding sudden speed changes; after braking resume pedalling prior to changing
the PAS setting.
EN
On/Off
Battery level indicator
Three-speed PAS mode
7